PLMP Report

Windows 7 64-
bit
Compliance Test For
Systems)
PCIHCT - Bit range 11:10 (ASPM Support)in the
Link Capabilities register (offset Ch) in the PCI
Express Capability table is 0h. It cannot be in
the set of values {0x0, 0x2}. (Assertion
5CAF4993-B8D1-4E4E-99EC-CC5895364E32)
Windows 7
PCI Hardware
Compliance Test For
Systems)
06/01/2011
423
Erratum
Issue Description:
Windows 7 64-
bit
Assertion 5CAF4993-B8D1-4E4E-99EC-
CC5895364E32 Bit range 11:10 (ASPM
Support)in the Link Capabilities register (offset
Ch) in the PCI Express Capability table is 0h. It
cannot be in the set of values {0x0, 0x2}.
Windows 7
UAA Test - Win7
(System)
12/31/2011
1670
Erratum
Issue Description:
Windows 7 64-
bit
HDMI audio devices are backed by video pipes;
if a graphics subsystem exposes three output
ports, but only has two video pipes, it is not
possible to get all three HDMI audio endpoints
"active" simultaneously.
Windows 7
UAA Test - Win7
(System)
06/01/2011
1300
Erratum
Issue Description:
Windows 7 64-
bit
HD Audio pin configuration document calls out
setting Port Connectivity to No Connection as
the way to turn a pin off in a particular system.
UAA Test incorrectly tests such pins.
Windows 7
UAA Test - Win7
(System)
07/01/2011
1466
Erratum
Issue Description:
Windows 7 64-
bit
Preview Filter: UAA Test - Intel Low Power
DCN says "EPSS implies KeepAlive, but only
after July 1st 2011"
Windows 7
UAA Test - Win7
(System)
02/28/2011
1299
Erratum
Issue Description:
Windows 7 64-
bit
Preview filter - Jack Detect Override on digital
pin widgets Errata 1299 The HD Audio
configuration default register (7.3.3.31 in the
HD Audio specification) includes a "Jack Detect
Override" flag that can be used to indicate that
although a pin widget would normally be
capable of jack detection, there is something
about this particular system that causes this to
be impossible. This was intended to be used,
for example, for analog pin widgets that are
connected to RCA jacks, which do not allow for
impedance detection. Some digital pin widgets
are using the Presence Detect pin sense
response to indicate that a digital handshake
has occured - indeed, HDMI pins have entire
DCNs built around this concept, and it applies
equally well to S/PDIF pins. A digital converter
that supports presence detection should be
able to do so in any system, so the "Jack
Detect Override" concept should not apply to
digital pins.
Windows 7
UAA Test - Win7
06/01/2015
513
Erratum
Issue Description: