PLMP Report

Reporting Capable bit in the Link Capabilities
register for a given PCIe port is set then that
indicates that the Data Link Layer Link Active bit
will also be set. This is an incorrect assumption
because the Data Link Link Layer Link Active bit
can be reset when there is no device below the
port. This assertion needs to be removed from the
PCIHCT. The current architecture of the PCIHCT
prevents it from knowing whether devices exist
below a bridge/port.
Resolution Description:
This is an acceptable failure: Assertion 0E36472A-
0EDB-4685-A67D-7AF1FFBFA81B Data Link
Layer Link Active Reporting Capable bit is set but
Data Link Layer Link Active is not.
Windows 7
Windows7 64 bit
UAA Test - Vista
or Server08
(System)
2/28/2011
1299
Erratum
Issue Description:
Preview filter - Jack Detect Override on digital pin
widgets Errata 1299 The HD Audio configuration
default register (7.3.3.31 in the HD Audio
specification) includes a "Jack Detect Override" flag
that can be used to indicate that although a pin
widget would normally be capable of jack
detection, there is something about this particular
system that causes this to be impossible. This was
intended to be used, for example, for analog pin
widgets that are connected to RCA jacks, which do
not allow for impedance detection. Some digital pin
widgets are using the Presence Detect pin sense
response to indicate that a digital handshake has
occurred - indeed, HDMI pins have entire DCNs
built around this concept, and it applies equally
well to S/PDIF pins. A digital converter that
supports presence detection should be able to do
so in any system, so the "Jack Detect Override"
concept should not apply to digital pins.
Resolution Description:
When this Errata expires, the issue described will
be considered a valid failure.
Windows 7
Windows7 64 bit
UAA Test - Vista
or Server08
(System)
6/1/2011
1300
Erratum
Issue Description:
HD Audio pin configuration document calls out
setting Port Connectivity to No Connection as the
way to turn a pin off in a particular system. UAA
Test incorrectly tests such pins.
Resolution Description:
This is an acceptable failure.
Windows 7
Windows7 64 bit
UAA Test - Vista
or Server08
(System)
6/1/2015
513
Erratum
Issue Description:
UAA Test requires the Traffic Priority bit to be
read/write - however there are two specs that
apply, and they conflict. One says the bit must be
read/write, the other says it must be read-only.
Contact has been made with the author of both
specs (Intel) but until this point is clarified we
cannot fail submissions containing this test failure.
Windows 7
Windows7 64 bit
USB Host
Controller
6/1/2012
1787
Erratum
Issue Description: