MLP Report

Windows Vista
Windows Vista 64bit
Windows 7
Windows 7 64-bit
PCI Hardware
Compliance
Test For
Systems
6/1/2011
923
Erratum
Assertion FAE18121-9177-4FB2-A081-0D04C285EFF2 Bit
range 15:0 (Extended Capability ID)in the Enhanced Capability
Header register (offset 0h) in the Unrecognized Enhanced
Capability ID 13 table is Dh. It must be in the range [0x0 - 0xB]
as all other Capability IDs are reserved.
Windows Vista
Windows Vista 64bit
Windows 7
Windows 7 64-bit
1)UAA Test -
Vista or
Server08
(System)
2) UAA Test -
Win7 (System)
6/1/2011
1300
Erratum
HD Audio pin configuration document calls out setting Port
Connectivity to No Connection as the way to turn a pin off in a
particular system. UAA Test incorrectly tests such pins.
Windows Vista
Windows Vista 64bit
Windows 7
Windows 7 64-bit
1)UAA Test -
Vista or
Server08
(System)
2) UAA Test -
Win7 (System)
2/28/2011
1299
Erratum
Preview filter - Jack Detect Override on digital pin widgets
Errata 1299 The HD Audio configuration default register
(7.3.3.31 in the HD Audio specification) includes a "Jack Detect
Override" flag that can be used to indicate that although a pin
widget would normally be capable of jack detection, there is
something about this particular system that causes this to be
impossible. This was intended to be used, for example, for
analog pin widgets that are connected to RCA jacks, which do
not allow for impedance detection. Some digital pin widgets are
using the Presence Detect pin sense response to indicate that a
digital handshake has occured - indeed, HDMI pins have entire
DCNs built around this concept, and it applies equally well to
S/PDIF pins. A digital converter that supports presence
detection should be able to do so in any system, so the "Jack
Detect Override" concept should not apply to digital pins.
Windows Vista
Windows Vista 64bit
Windows 7
Windows 7 64-bit
1)UAA Test -
Vista or
Server08
(System)
2) UAA Test -
Win7 (System)
6/1/2015
513
Erratum
UAA Test requires the Traffic Priority bit to be read/write -
however there are two specs that apply, and they conflict. One
says the bit must be read/write, the other says it must be read-
only. Contact has been made with the author of both specs
(Intel) but until this point is clarified we cannot fail submissions
containing this test failure.
Windows Vista
Windows Vista 64bit
Windows 7
Windows 7 64-bit
USB Host
Controller
Compliance
(Automated)
6/1/2012
1787
Erratum
Errata 1787 This Preview Test is being filtered until the
expiration date of this Errata. After the expiration date of this
filter these failures must be fixed to have a passing submission.
Microsoft strongly recommends that these errors be
investigated prior to this test or job being required for
submission. XHCI spec compliance test is in preview
Windows Vista 64bit
System -
Common
Scenario
Stress With IO
6/1/2011
1537
Erratum
The Disable Enable with IO test enumerates devices that can be
disabled early in the boot cycle. Some devices can be disabled
during the boot process, but later cannot be disabled. Since the
test does not check the device status each time, it may attempt
to disable a device that cannot be disabled.
Windows 7
Windows 7 64-bit
Graphics HDMI
System Test
(Manual)
6/1/2011
1717
Erratum
GraphicsHDMITest: should ignore pin widgets that have "Port
Connectivity" set to "No Physical Connection"
Windows 7
Windows 7 64-bit
1)Graphics
HDMI System
Test (Manual)
2) UAA Test -
Win7 (System
12/31/2011
1666
Erratum
graphics-hdmi-test-intel-two-of-three
Windows 7
Windows 7 64-bit
Graphics HDMI
System Test
(Manual)
6/1/2011
1945
Erratum
Failure is due to the ELDv2 PortId not matching the graphics
adapter LUID. This cannot be enforced currently. In the future,
video drivers will be required to program the ELDv2 PortId with
either, The AdapterLUID for the corresponding display adapter -
OR- 0