MLP Report

dropped from >= 1000 mVrms to >= 120 mVrms. This provides
freedom for manufacturers to meet both the EU <= 150 mVrms
@ 32 Ohms and the WLP >= 120 mVrms @ 32 Ohms
requirements. The Fidelity Test tests headphones at 300 Ohm
load, though. Without knowledge of the output impedance at the
jack, the test cannot extrapolate what the output level at 32
Ohms would have been from the output level at 300 Ohms. The
test assumes that the output level at 32 Ohms will be *less* than
the output level at 300 Ohms, though. So any measurement >=
120 mVrms at 300 Ohms "could be" a passing result, depending
on the output impedance.
Windows 7
Fidelity Test –
Win7 (System,
Manual)
6/01/2015
1012
Erratum
Issue Description:
Fidelity uses too small of a buffer and wakes up too infrequently
during the System Activity test. This causes errors like: Noise
level during system activity on (left or right) channel 73.2016 dB:
*** FAIL *** (requirement >= 80 dB)
Windows 7
Windows7 -
64bit
Signed Driver
Check (Manual)
12/01/2012
2346
Erratum
Issue Description:
The Signed Driver Check test may improperly fail with messages
related to the subsystem vendor ID of the integrated device. This
test assertion check for subsystem vendor IDs is being removed
from the next version of the test so we are no longer requiring
these test assertions to pass. This does not affect other checks
within the test and errors such as oemx.inf is not signed are
required to be fixed and pass.
Windows 7
Windows7 -
64bit
USB Host
Controller
Compliance
(Automated)
12/01/2012 1787 Erratum
Issue Description:
Errata 1787 This Preview Test is being filtered until the expiration
date of this Errata. After the expiration date of this filter these
failures must be fixed to have a passing submission. Microsoft
strongly recommends that these errors be investigated prior to this
test or job being required for submission. XHCI spec compliance
test is in preview
Test Notes
Operating System
Test
Description
Windows 7
BIOS
download
Internal: http://bios.intel.com/downloads/
External: http://www.intel.com/ click on Support and Download
Windows 7
BIOS setup Please make sure the BIOS setting are as below, otherwise use default
settings.
System Date and Time: Current date and time
Enhance Consumer IR: Enable
Others: BIOS default setting
Windows 7 filter
update
WLK WHQL
test
http://winqual.microsoft.com/member/SubmissionWizard/LegalExemptions/filte
rupdates.cab
Special H/W that
use to PASS the
test
None
None