PLMP Report

Errata and Contingencies
Operating System
Failing Test
Expiry
Date
ID
Number
Type
Error Description
Windows 7
Windows 7 64-bit
PCI Hardware
Compliance
Test For
Systems
12/01/2010
401
Erratum
The following PCI Compliance test failure is acceptable: Bit
15 (Bridge Configuration Retry Enable) in the Device Control
register (offset 8h) in the PCI Express Capability table must
be read-only and always return 0 as it is reserved for
devices other than PCI Express to PCI/PCI-X Bridges.
Assertion 13A41D3E-2576-41DC-A67C-525DA3637CEA
This failure is acceptable because this is a PCIe 1.1 feature
and the WLP requires compliance with only PCIe 1.0a.
Windows 7
Windows 7 64-bit
PCI Hardware
Compliance
Test For
Systems
12/01/2010
1241
Erratum
This happens because the PCI Compliance test assumes that
if the Data Link Layer Link Active Reporting Capable bit in
the Link Capabilities register for a given PCIe port is set then
that indicates that the Data Link Layer Link Active bit will
also be set. This is an incorrect assumption because the
Data Link Link Layer Link Active bit can be reset when there
is no device below the port. This assertion needs to be
removed from the PCIHCT. The current architecture of the
PCIHCT prevents it from knowing whether devices exist
below a bridge/port.
Windows 7
Windows 7 64-bit
Class Driver
AC3 Test -
Win7 (System)
06/30/2025
1256
Erratum
Run AC3 test on a system with the Microsoft HD Audio class
driver installed. Expected results: All AC3 kernel streaming
data ranges should advertise MinimumBitsPerSample = 16
and MaximumBitsPerSample = 16. Actual results: HD Audio
class driver sometimes advertises MaximumBitsPerSample =
24.
Windows 7
Windows 7 64-bit
Graphic HDMI
System Test
(Manual)
12/31/2011
1666
Erratum
Intel HDMI audio codec exposes three HDMI audio pins
(audio outputs) but there are only two video pipes so only
two of the three can be plugged in at any given time.
Test will need to be rejiggered to allow testing each in turn.
This errata applies only to
HDAUDIO\FUNC_01&VEN_8086&DEV_2804 and then only
when pins 5 and 6 are both plugged in; pin 4 errors, which
this errata covers.
Windows 7
Windows 7 64-bit
Graphic HDMI
System Test
(Manual)
12/01/2010
1717
Erratum
GraphicsHDMITest: should ignore pin widgets that have
"Port Connectivity" set to "No Physical Connection"
Windows 7
Windows 7 64-bit
Graphic HDMI
System Test
(Manual)
12/31/2010
1945
Erratum
Failure is due to the ELDv2 PortId not matching the graphics
adapter LUID. This cannot be enforced currently. In the
future, video drivers will be required to program the ELDv2
PortId with either, The AdapterLUID for the corresponding
display adapter -OR- 0
Windows 7
Windows 7 64-bit
UAA Test –
Win7 (System)
06/01/2015
513
Erratum
UAA Test requires the Traffic Priority bit to be read/write -
however there are two specs that apply, and they conflict.
One says the bit must be read/write, the other says it must
be read-only. Contact has been made with the author of
both specs (Intel) but until this point is clarified we cannot
fail submissions containing this test failure.