MLP Report

Test Notes
Operating
System
Failing Test
Expiry date
ID Number
Type
Error Description
Windows 7
/Windows 7 64
Fidelity Test - Vista (System,
Manual)
08/09/2010
2562
Erratum
Fidleity Render Power Transition test does
not work properly. The test is not going to
be enforced until a fix can be released.
GlitchFree WMV HD 720p video
playback quality test
06/01/2010
1245
The GlitchFree WMV HD 720p video
playback quality test enforces SYSFUND-
0062 Case 2 and 3 were added to enhance
the verification of the video playback test.
These cases will be in preview state until
this errata expires.
If cases 2 or 3 of the GFHD test fail for any
reason while this errata is active, then the
failures should be fitered out. Cases 0 and 1
do not apply to this errata and remain a
requirement.
Class Driver Fidelity Test - Win7
(System, Manual)
08/09/2010
1670
EU restrictions place a cap on the output
level of headphone jacks at 32 Ohm load:
headphones are not allowed to have an
electrical output of more than 150 mV at
that load.
08/09/2010
2562
Fidleity Render Power Transition test does
not work properly.
Class Driver AC3 Test - Win7
(System)
06/01/2010
1890
The HD Audio class driver hdaudio.sys
exposes AC-3 data ranges on S/PDIF Kernel
Streaming pins incorrectly.
PCI Hardware Compliance Test
For Systems
12/01/2010
385
Bit 15 (Bridge Configuration Retry Enable) in
the Device Control register (offset 8h) in the
PCI Express Capability table must be read-
only and always return 0 as it is reserved
for devices other than PCI Express to
PCI/PCI-X Bridges. Assertion 13A41D3E-
2576-41DC-A67C-525DA3637CEA This
failure is acceptable because this is a PCIe
1.1 feature and the WLP requires
compliance with only PCIe 1.0a.
12/01/2010
759
Bit range 11:10 (ASPM Support)in the Link
Capabilities register (offset Ch) in the PCI
Express Capability table is 0h. It cannot be in
the set of values {0x0, 0x2}
12/31/2010
1543
Data Link Layer Link Active Reporting
Capable bit is set but Data Link Layer Link
Active is not.
UAA Test - Win7 (System)
08/09/2010
1394
UAA Test requires the Traffic Priority bit to
be read/write - however there are two
specs that apply, and they conflict. One says
the bit must be read/write, the other says it
must be read-only. Contact has been made
with the author of both specs (Intel) but
until this point is clarified we cannot fail
submissions containing this test failure.