MLP Report

register for a given PCIe port is set then that
indicates that the Data Link Layer Link Active bit
will also be set. This is an incorrect assumption
because the Data Link Link Layer Link Active bit
can be reset when there is no device below the
port. This assertion needs to be removed from
the PCIHCT. The current architecture of the
PCIHCT prevents it from knowing whether
devices exist below a bridge/port.
Resolution Description:
This is an acceptable failure: Assertion
0E36472A-0EDB-4685-A67D-7AF1FFBFA81B
Data Link Layer Link Active Reporting Capable
bit is set but Data Link Layer Link Active is not.
Windows 7
Windows7 64 bit
UAA Test - Vista
or Server08
(System)
2/28/2011
1299
Erratum
Issue Description:
Preview filter - Jack Detect Override on digital
pin widgets Errata 1299 The HD Audio
configuration default register (7.3.3.31 in the HD
Audio specification) includes a "Jack Detect
Override" flag that can be used to indicate that
although a pin widget would normally be capable
of jack detection, there is something about this
particular system that causes this to be
impossible. This was intended to be used, for
example, for analog pin widgets that are
connected to RCA jacks, which do not allow for
impedance detection. Some digital pin widgets
are using the Presence Detect pin sense
response to indicate that a digital handshake has
occurred - indeed, HDMI pins have entire DCNs
built around this concept, and it applies equally
well to S/PDIF pins. A digital converter that
supports presence detection should be able to
do so in any system, so the "Jack Detect
Override" concept should not apply to digital
pins.
Resolution Description:
When this Errata expires, the issue described
will be considered a valid failure.
Windows 7
Windows7 64 bit
UAA Test - Vista
or Server08
(System)
6/1/2011
1300
Erratum
Issue Description:
HD Audio pin configuration document calls out
setting Port Connectivity to No Connection as
the way to turn a pin off in a particular system.
UAA Test incorrectly tests such pins.
Resolution Description:
This is an acceptable failure.
Windows 7
Windows7 64 bit
UAA Test - Vista
or Server08
(System)
6/1/2015
513
Erratum
Issue Description:
UAA Test requires the Traffic Priority bit to be
read/write - however there are two specs that
apply, and they conflict. One says the bit must
be read/write, the other says it must be read-
only. Contact has been made with the author of
both specs (Intel) but until this point is clarified
we cannot fail submissions containing this test
failure.
Windows 7
Windows7 64 bit
USB Host
Controller
Compliance
(Automated)
6/1/2012
1787
Erratum
Issue Description:
Errata 1787 This Preview Test is being filtered
until the expiration date of this Errata. After the