User's Manual

Chapter 4 Award BIOS Setup

Page: 4-14

PCI-471LF USER

′

S MANUAL

hard drive and your system software both support Ultra DMA/33,

select Auto to enable BIOS support.

4. IDE HDD Block Mode

Block mode is also called block transfer, multiple commands, or

multiple sector read/write. If your IDE hard drive supports block mode

(most new drives do), select Enabled for automatic detection of the

optimal number of block read/writes per sector the drive can support.

ONBOARD DEVICE:

The options for these items are found in its sub menu. By pressing the

<ENTER> key, you are prompt to enter the sub menu of the detailed options

as shown below:

Phoenix – Award CMOS Setup Utility

Onboard Device

Item Help

USB Controller

USB 2.0 Support

USB Keyboard Support

USB Mouse Support

Onboard LAN

Init Display First

[Enabled]

[Disabled]

[Enabled]

[Onboard]

Menu Level ►

↑↓→←:Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help

F5: Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults

Descriptions on each item above are as follows:

1. USB Controller

This should be enabled if your system has a USB installed on the

system board and you want to use it. Even when so equipped, if you

add a higher performance controller, you will need to disable this

feature.

2. USB Keyboard Support

Select Enabled if your system contains a Universal Serial Bus (USB)

controller and you have a USB keyboard.

3. USB Mouse Support

Select Enabled if your system contains a Universal Serial Bus (USB)

controller and you have a USB Mouse.

4. Init Display First

This item allows you to decide to active whether PCI Slot or on-chip

VGA first.