User's Manual

Vol. 3 8-69
MULTIPLE-PROCESSOR MANAGEMENT
JE Get_Lock
PAUSE ;Short delay
JMP Spin_Lock
Get_Lock:
MOV EAX, 1
XCHG EAX, lockvar ;Try to get lock
CMP EAX, 0 ;Test if successful
JNE Spin_Lock
Critical_Section:
<critical section code>
MOV lockvar, 0
...
Continue:
The spin-wait loop above uses a “test, test-and-set” technique for determining the
availability of the synchronization variable. This technique is recommended when
writing spin-wait loops.
In IA-32 processor generations earlier than the Pentium 4 processor, the PAUSE
instruction is treated as a NOP instruction.
8.10.6.2 Potential Usage of MONITOR/MWAIT in C0 Idle Loops
An operating system may implement different handlers for different idle states. A
typical OS idle loop on an ACPI-compatible OS is shown in Example 8-24:
Example 8-24. A Typical OS Idle Loop
// WorkQueue is a memory location indicating there is a thread
// ready to run. A non-zero value for WorkQueue is assumed to
// indicate the presence of work to be scheduled on the processor.
// The idle loop is entered with interrupts disabled.
WHILE (1) {
IF (WorkQueue) THEN {
// Schedule work at WorkQueue.
} ELSE {
// No work to do - wait in appropriate C-state handler depending
// on Idle time accumulated
IF (IdleTime >= IdleTimeThreshhold) THEN {
// Call appropriate C1, C2, C3 state handler, C1 handler
// shown below
}
}
}