User's Manual

10-24 Vol. 3
ADVANCED PROGRAMMABLE INTERRUPT CONTROLLER (APIC)
The default value for SVR[bit 12] is clear, indicating that an EOI broadcast will be
performed.
The support for Directed EOI capability can be detected by means of bit 24 in the
Local APIC Version Register. This feature is supported in both the xAPIC mode and
x2APIC modes of a local x2APIC unit. Layout of the Local APIC Version register is as
shown in
Figure 10-10. The Directed EOI feature is supported if bit 24 is set to 1.
10.5.6 x2APIC State Transitions
This section provides a detailed description of the x2APIC states of a local x2APIC
unit, transitions between these states as well as interactions of these states with INIT
and RESET.
10.5.6.1 x2APIC States
The valid states for a local x2APIC unit is listed in Table 10-2:
• APIC disabled: IA32_APIC_BASE[EN]=0 and IA32_APIC_BASE[EXTD]=0
Figure 10-9. Spurious Interrupt Vector Register (SVR) of x2APIC
Figure 10-10. Local APIC Version Register of x2APIC
31
0
Reserved
7
APIC Software Enable/Disable
8911
0: APIC Disabled
1: APIC Enabled
Spurious Vector
MMIO Address: FEE0 00F0H
MSR Address: 080FH
EOI Broadcast Disable
12
31
0
Reserved
78
23 15
MMIO Address: FEE0 0030H
MSR Address: 0803H
Directed EOI Support
16
Reserved
25
24
Vector
Max LVT Entry