Network Card User Manual

Configure the Controller and Install Drivers 7
Install Network Drivers - Windows NT Version 3.51 Only
After enabling the OBEC in the computer and starting Windows NT, you
need to install the correct drivers and test the controller.
1.
Double-click the Network icon in the Control Panel.
2.
Click Add Adapter.
3.
When the list of adapters appears, scroll to the end of the list and select
<Other> Requires disk from manufacturer.
4.
Insert the Configuration and Drivers disk in the drive and click OK.
Drivers and the PROSet utility are installed and PROSet starts.
PROSet is an enhanced utility that you can use to easily configure and
test your controller in Windows NT. PROSet also displays the
computer resources that were assigned to each adapter installed. The
PROSet main window is shown on the preceding page.
5.
Click OK in the PROSet main window to return to Windows NT.
You’ll see the Network Settings dialog box.
6.
Click OK and remove the installation disk. When prompted, restart
Windows NT.
To install multiple adapters, repeat this procedure for each new
adapter. For more information, see “Installing Multiple Adapters” on
page 11.
Troubleshooting
If Windows NT reports an error or you can’t connect to the network, try the
suggestions here first, then turn to “Troubleshooting and FAQs” on page 24
if necessary.
•
Make sure that you use the drivers for this controller. Drivers are
located on the Configuration and Drivers disk, version 3.0 or later.
•
Make sure the driver is loaded and the protocols are bound. Check
the Network Bindings dialog box in Windows NT.
Installing the Windows NT 3.51 Drivers
ENet2.book Page 7 Monday, May 4, 1998 9:53 AM