Datasheet

Package Mechanical Specifications and Pin Information
54 Datasheet
DBR# Output
DBR# (Data Bus Reset) is used only in processor systems where no
debug port is implemented on the system board. DBR# is used by a
debug port interposer so that an in-target probe can drive system
reset. If a debug port is implemented in the system, DBR# is a no
connect in the system. DBR# is not a processor signal.
DBSY#
Input/
Output
DBSY# (Data Bus Busy) is asserted by the agent responsible for
driving data on the FSB to indicate that the data bus is in use. The
data bus is released after DBSY# is de-asserted. This signal must
connect the appropriate pins on both FSB agents.
DEFER# Input
DEFER# is asserted by an agent to indicate that a transaction cannot
be ensured in-order completion. Assertion of DEFER# is normally the
responsibility of the addressed memory or Input/Output agent. This
signal must connect the appropriate pins of both FSB agents.
DINV[3:0]#
Input/
Output
DINV[3:0]# (Data Bus Inversion) are source synchronous and
indicate the polarity of the D[63:0]# signals. The DINV[3:0]# signals
are activated when the data on the data bus is inverted. The bus
agent will invert the data bus signals if more than half the bits, within
the covered group, would change level in the next cycle.
DPRSTP# Input DPRSTP# is not used by the Celeron processor.
DPWR# Input
DPWR# is a control signal used by the chipset to reduce power on
the processor data bus input buffers. This is not used by the
processor.
DRDY#
Input/
Output
DRDY# (Data Ready) is asserted by the data driver on each data
transfer, indicating valid data on the data bus. In a multi-common
clock data transfer, DRDY# may be de-asserted to insert idle clocks.
This signal must connect the appropriate pins of both FSB agents.
DSTBN[3:0]#
Input/
Output
Data strobe used to latch in D[63:0]#.
Table 19. Signal Description (Sheet 3 of 8)
Name Type Description
DINV[3:0]# Assignment to Data Bus
Bus Signal Data Bus Signals
DINV[3]# D[63:48]#
DINV[2]# D[47:32]#
DINV[1]# D[31:16]#
DINV[0]# D[15:0]#
Signals Associated Strobe
D[15:0]#, DINV[0]# DSTBN[0]#
D[31:16]#, DINV[1]# DSTBN[1]#
D[47:32]#, DINV[2]# DSTBN[2]#
D[63:48]#, DINV[3]# DSTBN[3]#