Intel Pentium 4 Processor in the 478-PinPackage at 1.40 GHz, 1.50 GHz, 1.60 GHz, 1.70 GHz, 1.80 GHz, 1.90 GHz, and 2GHz

Boxed Processor Specifications

Datasheet 87

8.0 Boxed Processor Specifications

8.1 Introduction

The Pentium 4 processor in the 478-pin package will also be offered as an Intel boxed

processor. Intel boxed processors are intended for system integrators who build systems

from motherboards and standard components. The boxed Pentium 4 processor in the

478-pin package will be supplied with a cooling solution. This chapter documents

motherboard and system requirements for the cooling solution that will be supplied with

the boxed Pentium 4 processor in the 478-pin package. This chapter is particularly

important for OEMs that manufacture motherboards for system integrators. Unless

otherwise noted, all figures in this chapter are dimensioned in millimeters and inches [in

brackets]. Figure 32 shows a mechanical representation of a boxed Pentium 4 processor

in the 478-pin package.

NOTE: Drawings in this section reflect only the specifications on the Intel boxed processor

product. These dimensions should not be used as a generic keep-out zone for all cooling

solutions. It is the system designer's responsibility to consider their proprietary cooling

solution when designing to the required keep-out zone on their system platform and

chassis. Refer to the Intel® Pentium® 4 Processor in the 478-pin Package Thermal

Design Guidelines for further guidance. Contact your local Intel Sales Representative for

this document.

NOTE: The airflow of the fan heatsink is into the center and out of the sides of the fan heatsink.

Figure 32. Mechanical Representation of the Boxed Intel

Pentium

4Processorinthe478-

Pin Package