Users guide

Intel® RAID Software User Guide 136
Figure 70. Intel
®
RAID BIOS Console 2 – Multiple Disk Groups for RAID 10,
50, or 60
7. Select all arrays or disk groups that are to
be spanned in the RAID 10, 50, or 60
array by holding down the <Ctrl> key and selecting each array/disk group in the
right pane.
8. Click Ne
xt.
9. In the next screen, click Ad
d to SPAN to move all arrays from the left pane to the
right pane. Use <Ctrl> to select all SPANs on the right pane.
10. Click Ne
xt.
11. At the Virtual Drive Definition (VD Definition) screen, select
either RAID 10,
RAID 50, or RAID 60 from the RAID Level drop-down.
RAID 10 is illustrated below.
12. Select the appropriate Stripe Size, Access Policy, Read Policy, Write Policy, IO
P
olicy, Disk Cache Policy, and Enable/Disable BGI for your application.
For information about setting these parameters, see “Setting Drive Parameters” on
page 141.
13. Set the drive size to a number in MB that
is a size greater then the size of the RAID
1, RAID 5, or RAID 6 size listed in the disk group.