Technical Product Specification
Firmware Functional Specification Intel® Local Control Panel for EPSD Platforms TPS
Intel order number G83726-001 Revision 1.0
12
and the following screen is displayed on selecting any of IPAddr, SMask, and GWay items. The
selected item will be set with the configured value once Set is selected in the following figure.
Figure 21: Screen shot for Configuring IP Address, Subnet Mask, and Gateway
By default, the cursor will be under the symbol, and the IP address is displayed as
000.000.000.000. A Right button will take the cursor to the first position (first 0) of the IP
address. When the cursor is under the second menu item, the functionality of Left, Right and
Enter buttons is different from the previous screens. The second token consists of twelve 0’s
separated by ‘.’ character in IP address format. The behaviors of these buttons are as follows
when the cursor is under this item.
1. Left and Right buttons inside the second menu item traverses among the 0 positions
within the same item.
2. If the cursor is under last position inside the second menu item, then a Right button
will move the cursor to next item, that is, Set.
3. If the cursor is under first position inside the second menu item, then a Left button
moves the cursor to the previous item, that is .
4. First Enter button at any “0” position makes that position to be selected to increment
or decrement the value at that position. The values allowed are between and
including 0 and 9.
5. Any further Left or Right buttons will decrement or increment the value at that
position.
6. Second Enter button at that position makes the cursor to be ready for moving left or
right. Any further left or right movement shifts the cursor to the previous or next
position respectively.
7. So, the Enter button is used to select a position at the first time and to leave the
position at the second time.
The following state transition diagram explains the above steps pictorially, while setting an IP
address using the LCD device. After entering an IP address, the user has to select Set item to
set the entered IP address to the corresponding parameter (IP Address, Subnet Mask, or
Gateway).
|000.000.000.000|Set