User Guide

Intel® BMC And RMM4 User Guide Hardware Installations and Initial Configuration
Revision 2.8 Intel order number H54847-001 19
3.3.2.1.3 Installing the Dedicated NIC on Intel
®
Server System R1000EP Family
1. Ensure that AC power has been removed from the system and that you have waited at
least 30 seconds after removing power.
2. Push out and remove the metal cover on the chassis where the NIC RJ-45 receptacle will
align.
Caution: Carefully remove the metal cover with pliers; directly removing it with fingers has
a potential risk.
3. Insert and fit the metal adapter into the position as shown in Figure 10. Secure the adapter
with two screws as shown (see letter B).
4. Position the module over the server board, fit the front of the module into the back panel
slot, and then attach the module to the server board connector. Secure the module with
the one screw as shown (see letter C).
Figure 10: Adding the Intel
®
Dedicated Server Management NIC Module in the Intel
®
Server System
R1000EP Family