Quick Installation Guide Part 2

12
General Installation Process
16
Reinstall Front Bezel Assembly
A
B
Engage three plastic bezel hooks into the raised metal
slots at the chassis edge. Keep the right edge of front
bezel align tightly with the right edge of the Chassis.
Rotate the bezel assembly toward the chassis and latch
the two plastic tabs on the left side of the bezel
assembly to the chassis.
A
A
A
B
B
17
Install Feet (pedestal only)
Insert rubber foot into chassis hole.
Note: Repeat above steps until all four feet are installed.
A
Secure foot by inserting pin through the rubber foot.
B
A
B
Note: This step applies to your chassis if configured as a pedestal
system. If you plan to configure your chassis as a rack-mount system,
disregard this step.
18
Install Air Duct
A
B
Install the air duct. Ensure that alignment holes and tabs
match up.
Align the air duct and chassis rail.
Note: Please order the air duct that compatible with your server board
and chassis.
Chassis
alignment holes
Air Duct
alignment tabs
B
A
19
Install Side Cover
B
A
Slide the chassis cover on the chassis.
Secure the chassis cover with the screws .
CAUTION: This chassis must be operated with the
SIDE COVERS installed to ensure proper cooling.
B
B
A