Server Management Guide
Scenarios and Best Practices
Intel
®
Server Boards and Server Platforms Server Management Guide 89
Figure 48. EMS setting results
Reboot the server in order for the changes to take effect.
NOTE
To turn EMS off again, issue the following command:
bootcfg /ems off /id 1
Where 1 is the boot entry you modified in the preceding steps. Reboot the server to bring the
changes online.
Once you reboot and engage the DPCCLI console, you will see the EMS console.
Tip: After you start the DPCCLI console, if you only get a blank screen, press the <Enter> key a
few times to get the SAC> prompt.
You can now issue the various SAC commands.