Technical product specification

Intel
®
Server System P4000CP Power System Options Intel
®
Server Board S2600CP and Server System P4000CP TPS
Revision 1.8
Intel order number G26942-005
146
The power supply meets the requirements under the following AC line sag and surge conditions.
Table 97. AC Line Sag Transient Performance
AC Line Sag (10sec interval between each sagging)
Duration
Sag
Operating AC Voltage
Line Frequency
Performance Criteria
0 to ½ AC
cycle
95%
Nominal AC Voltage ranges
50/60Hz
No loss of function or performance
> 1 AC cycle
>30%
Nominal AC Voltage ranges
50/60Hz
Loss of function acceptable, self
recoverable
Table 98. AC Line Surge Transient Performance
AC Line Surge
Duration
Surge
Operating AC Voltage
Line Frequency
Performance Criteria
Continuous
10%
Nominal AC Voltages
50/60Hz
No loss of function or performance
0 to ½ AC
cycle
30%
Mid-point of nominal AC
Voltages
50/60Hz
No loss of function or performance
13.3.2.7 Power Recovery
The power supply shall recover automatically after an AC power failure. AC power failure is
defined to be any loss of AC power that exceeds the dropout criteria.
13.3.3 Efficiency
The following table provides the required minimum efficiency level at various loading conditions.
These are provided at three different load levels; 100%, 50%, 20%, and 10%. Output shall be
loaded according to the proportional loading method defined by 80 Plus in Generalized Internal
Power Supply Efficiency Testing Protocol Rev. 6.4.3. This is posted at
http://efficientpowersupplies.epri.com/methods.asp.
Table 99. Silver Efficiency Requirement
Loading
100% of maximum
50% of maximum
20% of maximum
10% of maximum
Minimum Efficiency
91%
94%
90%
82%
The power supply passes with enough margins to make sure that all power supplies meet these
efficiency requirements in production.
13.3.4 DC Output Specification
13.3.4.1 Output Power/Currents
The following table defines the minimum power and current ratings. The power supply meets
both static and dynamic voltage regulation requirements for all conditions.
Table 100. Minimum Load Ratings
Parameter
Min
Max.
Peak 2, 3
Unit
12V main
0.0
62.0
70.0
A
12Vstby 1
0.0
2.1
2.4
A