Technical Product Specification

Connector/Header Locations and Pin-outs Intel® Server System SC5650HCBRP TPS
Revision 1.2
Intel order number E81443-002
160
One low-profile 2x5 connector (J2D2) on the server board provides an option to support a low-
profile USB Solid State Drive.
Table 113. Pin-out of Internal Low-Profile USB Connector for Solid State Drive (J2D2)
Pin Signal Name Description
1 USB_PWR11_5V USB power
2 NC Not Connected
3 USB Data - USB port 11 negative signal
4 NC Not Connected
5 USB Data + USB port 11 positive signal
6 NC Not Connected
7 Ground Ground
8 NC Not Connected
9 Key No pin
10 LED# Activity LED
The server boards provide one additional Type A USB port (J1H2) to support the installation of
a USB device inside the server chassis.
Table 114. Internal Type A USB Port Pin-out (J1H2)
Pin Signal Name Description
1 USB_PWR7_5V USB_PWR
2 USB_ICH_P7N USB port 7 negative signal
3 USB_ICH_P7P USB port 7 positive signal
4 GND Ground
8.6 Fan Headers
The server board provides three SSI-compliant 4-pin and four SSI-compliant 6-pin fan headers
to use as CPU and I/O cooling fans. 3-pin fans are supported on all fan headers. 6-pin fans are
supported on headers J1K1, J1K2, J1K4, and J1K5. 4-pin fans are supported on headers J1K1,
J1K2, J1K4, J1K5, J7K1, J9A2, and J9A3. The pin configuration for each of the 4-pin and 6-pin
fan headers is identical and defined in the following tables.
 Two 4-pin fan headers are designated as processor cooling fans:
- CPU1 fan (J9A2)
- CPU2 fan (J7K1)
 Four 6-pin fan headers are designated as hot-swap system fans:
- Hot-swap system fan 1 (J1K1)
- Hot-swap system fan 2 (J1K4)
- Hot-swap system fan 3 (J1K2)
- Hot-swap system fan 4 (J1K5)
 One 4-pin fan header is designated as a rear system fan:
- System fan 5 (J9A3)