Report

Errata and Contingencies Intel® Server Board SDS2
12 6/25/2002
Additional Information
Data in this section reflects product data and additional information entered in section 3 of the SDS2
Readme file at time of the initial WLP First Time submission.
• FullDuplex Test not required for server submissions if no audio device is implemented. The SDS2
server does not have an audio device implemented. FullDuplex Test was not run.
• DSound Driver Test not required for server submissions if no audio device is implemented. The
SDS2 server does not have an audio device implemented. DSound Driver Test was not run.
• Wave Driver Test not required for server submissions if no audio device is implemented. The SDS2
server does not have an audio device implemented. Wave Driver Test was not run.
• Due to Windows 2000 Advanced Server operating system limitations server systems that support
4GB or more of memory are tested with maximum memory installed for all HCTs except for the
ACPI HCTs. Memory is removed in order to bring the total system memory below 4GB to enable
Windows 2000 Advanced Server to go into hibernation. Refer to errata ID: 92.
• Preview PCI Pre-OS tests fail. Following preview PCI Pre-OS are not required to pass. The
following test failures are acceptable.
o PCIWAKE (System Wake-up Test)
o PCIWAKEA (System Wake-up TestA)
o PCIVAUX (3.3Vaux Auxiliary Power Load Test)
o PCIPME1 (PME# Signal Routing Test):
o PCIPME2 (Simultaneous PME# Signal Assertion Test)
Operating system
(Windows* XP, Windows 2000, etc.)
Failure type
(Contingency, Errata, Incident)
ID number
Windows 2000 Errata 722
Failing test name
PCI 2.1 (Cards) Test
Applicable error message
(Type N/A if the error message or
failing text is excessive or if there
is no text)
Errata Title: PCI 2.2 Compliance test and PCI 2.1 (Cards) test might fail test
systems with ATA/ATAPI controllers
Problem:
PCI2.1 (Cards) test fails with the following error:
BAR is 0x00002491, Length of BAR is 0xFFFF0004
ERROR: Base register 24 should be zero (read-only)!
No Extended capabilities required for this device