Report

Errata and Contingencies Intel® Server Board SCB2 ATA
16 January 22, 2003
Additional Information for First-Time Submission
Data in this section reflects product data and additional information entered in section 3 of the Intel®
Server Board SCB2 ATA Readme file at time of WLP submission.
• To pass the Serial Port(COM2) HCT either use a RJ45 loopback connector that meets HCT
requirements or use the SCB2 RJ45 to DB9 adapter and an appropriate DB9 loopback connector
attached to the SCB2 RJ45 serial connector then run the HCTs. Refer to the Intel SCB2 Attention
sheet # A77758-001 and the SCB2 Product Guide regarding configuration of the RJ45 serial
connector and the RJ45 to DB9 adapter for more information.
• Due to Windows* 2000 Advanced Server operating system limitations server systems that support
4GB or more of memory are tested with maximum memory installed for all HCTs except for the
ACPI HCTs. Memory is removed in order to bring the total system memory below 4GB to enable
Windows 2000 Advanced Server to go into hibernation. Refer to errata ID: 92 and the AWE Test
procedures for more information.