Command Line Tool 2 User Guide

Intel
®
RAID Controller Command Line Tool 2 User Guide
Functional Group Command Command Function
-PdOnline Set the Drive State to Online
-PDOffline Set the Drive State to Offline
-PDMakeGood Change the Drive State to Unconfigured Good
-PDHSP Change the Hot Swap Drive State
-PDClear Manage a Drive Initialization
-PDRbld Manage a Drive Rebuild
-PDlocate Locate the Drives and Activate LED
-PDMarkMissing Mark the Configured Drive as Missing
-PDGetMissing Show the Drive in Missing Status
-PDReplaceMissing Replace the Configured Drives and Start Rebuild
-PDPrpRmv Prepare the Unconfigured Drive for Removal
-PDGetNum Show Total Number of Drives
-PDList Show List of Physical Drives
-PDFwDownload Download Firmware to the Physical Devices
-CfgAllFreeDrv Configure All Free Drive into a RAID
-DirectPdMapping Set the Mapping Mode of the Drives
-PdCpyBk Perform the Copyback Operation
Enclosure-Related Options
-EncInfo Show Enclosure Information
-EncStatus Show Enclosure Status
Flashing the Firmware
-AdpFwFlash Flash the Firmware with the ROM File
-AdpM0Flash Flash the Firmware in Mode 0 with the ROM File
(DOS only)
SAS Topology
-PHYInfo Show PHY Connection Inforamtion
Diagnostic Related Options
-AdpDiag Start Controller Diagnostics
-AdpBatTest Start Battery Test
-AdpNVRAM Starts the NVRAM diagnostic. (DOS only)
Full Disk Encryption (SafeStore Security) Related Options
-PDInstantSecureErase Use Instant Secure Erase on a Physical Drive
-LDMakeSecure Secure Data on a Virtual Drive