Command Line Tool 2 User Guide

Intel
®
RAID Controller Command Line Tool 2 User Guide
AdpBatTest
Description
This command tests the battery back up device and is only valid if a battery back-up unit is installed.
This command requires a system reboot.
Syntax
CmdTool2 -AdpBatTest -a[controller]
Parameters
-a[controller]: The RAID controller affected by the command
Example
CmdTool2 -AdpBatTest -aALL
AdpBbuCmd
Description
Displays complete information about the BBU,
Syntax
CmdTool2 -AdpBbuCmd -GetBbuStatus | -GetBbuCapacityInfo | -GetBbuDesignInfo |
-GetBbuPropertie | -BbuLearn | -BbuMfgSleep | -SetBbuProperties -f [filename]
-a[controller]
Parameters
-a[controller]: The RAID controller affected by the command
-GetBbuStatus: Displays complete information about the BBU status, such as the temperature and
voltage.
-GetBbuCapacityInfo: Displays BBU capacity information.
-GetBbuDesignInfo: Displays information about the BBU design parameters.
-GetBbuPropertie: Displays current properties of the BBU.
-BbuLearn: Starts the learning cycle on the BBU.
-BbuMfgSleep: Places the battery in Low-Power Storage mode.