Command Line Tool 2 User Guide

-SetBbuProperties: Sets the BBU properties on the selected controller(s) after reading from the file.

Note: You can change only two of these parameters: learnDelayInterval and auto LearnMode

Example

CmdTool2 -AdpBbuCmd -GetBbuStatus -a1

AdpBIOS

Description

Enables, disables, or displays the BIOS status on the selected RAID controller.

Syntax

DsblAutoSelectBootLd | -Dsply -a[controller]

Parameters

-a[controller]: The RAID controller affected by the command

-Enbl: Enable the BIOS on the RAID controller

-Dsbl: Disable the BIOS on the RAID controller

-SOE: Stops POST on BIOS errors. When set to -SOE, the Bios Stops in case of a problem with

the configuration. This gives you the option to enter the configuration utility to resolve the problem.

This is available only when you enable the BIOS status.

-BE: Bypasses BIOS errors during POST. This is available only when you enable the BIOS status.

-Dsply: Displays the BIOS status on the selected controller(s).

-EnblAutoSelectBootLd: Enable automatic selection of the boot virtual drive.

-DsblAutoSelectBootLd: Disable automatic selection of the boot virtual drive.

Example

CmdTool2 -AdpBIOS -Enbl -a1