Command Line Tool 2 User Guide

Parameters
-a[controller]: The RAID controller affected by the command
-[parameter(s)]: See the following list of allowed parameters
-CacheFlushInterval: Show the cash flush interval
-RebuildRate: Show the rebuild rate
-PatrolReadRate: Show the patrol read rate
-BgiRate: Show the background initialization rate
-CCRate: Show the consistency check rate
-ReconRate: Show the reconstruction rate
-SpinupDriveCount: Show the pinup drive count
-SpinupDelay: Show the spinup delay time
-CoercionMode: Show the coercion mode
-PredFailPollInterval: Show the interval used to poll for predicting failure
-EccBucketSize: Show the ECC bucket size
-EccBucketLeakRate: Show the ECC bucket leak rate
-EccBucketCount: Show the number of ECC buckets
-ClusterEnable: Show if Cluster is supported
-BatWarnDsbl: Show if the battery warning is disabled
-AlarmDsply: Show the Alarm setting
-SMARTCpyBkEnbl: Show if copyback operation on SMART is enabled.
-AutoDetectBackPlaneDsbl: Detect automatically backplane if the backplane is enabled.
-CopyBackDsbl: Show if the copyback operation is enabled.
-LoadBalanceMode: Show if the load balancing modeis enabled.
-NCQDsply: Show if the native command queueing is enabled.
-SSDSMARTCpyBkEnbl: Show if copyback operation on SMART errors on a SSD is enabled.
-MaintainPdFailHistoryEnbl: Show if maintenance of the history of a failed