Command Line Tool 2 User Guide

Parameters
None
Example
CmdTool2 -AdpM0Flash -f filename
AdpNVRAM
Description
Starts the NVRAM diagnostic.This option is for DOS only.
Syntax
cmdtool2 -AdpNVRAM {-Read|-Write -f filename} | -clear [-
startOffset 0xXXXX] [-EndOffset] -a[controller]
Parameters
-Read: Reads the content in NVRAM and writes the data to file filename
-Write: Reads data from file filename and writes to NVRAM
-Clear: Writes 0 to NVRAM
-StartOffset, EndOffset: Specifies the start offset and/or end offset in NVRAM
Example
Cmdtool2 -AdpNVRAM -Read -f filename -a1
AdpPR
Description
Start, stop, or show the progress of a patrol read.
Syntax
CmdTool2 -AdpPR -Dsbl | EnblAuto | EnblMan | Start | Stop | Info |SSDPatrolReadEnbl |
SSDPatrolReadDsbl | {-SetStartTime yyyymmdd hh} | maxConcurrentPD
-a[controller]