Command Line Tool 2 User Guide

AdpShutDown
Description
Shut down the RAID controller.
Syntax
CmdTool2 -AdpShutDown -a[controller]
Parameters
-a[controller]: The RAID controller affected by the command
Example
CmdTool2 -AdpShutDown -a1
CfgAllFreeDrv
Description
Configure All Free Drives into a RAID 0, 1, 5, or 6 Configuration for a Specific Controller
Syntax
CmdTool2 -CfgAllFreeDrv -rX [-SATAOnly] [-SpanCountXXX] [WT|WB] [NORA|RA|ADRA]
[Direct|Cached] [CachedBadBBU|NoCachedBadBBU] [-strpszM] [-HspCountXX [-HspType
-Dedicated|-EnclAffinity|-nonRevertible]] | [FDE|CtrlBased] -a[controller]
Parameters
-a[controller]: The RAID controller affected by the command
Rx[E0:S0,...]: Specifies the RAID level and the physical driveenclosure/slot numbers to construct a
disk group.
-RW: Set the array to read-write
-RO: Set the array to read-only
-Blocked: Blocked array access
-WT: Set the array to write-through
-WB: Set the array to write-back