Command Line Tool 2 User Guide

Intel
®
RAID Controller Command Line Tool 2 User Guide
-l[drive]: The drive(s) affected by the command
Example
CmdTool2 -LDInit -Start -full -l0 -a1
LdPDInfo
Description
Display information about the present virtual drives and drives
Syntax
CmdTool2 -LdPDInfo -PhysDrv[E0:S0,E1:S1....] -a[controller]
Parameters
-a[controller]: The RAID controller affected by the command
Example
CmdTool2 -LdPDInfo -a1
LDRecon
Description
Controls and manages virtual drive reconstruction.
Syntax
CmdTool2 -LDRecon {-Start -RX[Add | Rmv -Physdrv[E0:S0,...]]} |
-ShowProg | -ProgDsply -L[drive] -a[controller]
Parameters
-a[controller]: The RAID controller affected by the command
-L[drive]: The drive(s) affected by the command
-Start: Start the reconstruction
-RX: Set the reconstruction RAID level
-Add: Add a drive