Command Line Tool 2 User Guide

-Rmv: Remove a drive
-Physdrv[E0:S0,...]: The drive to add or remove
-ShowProg: Displays a snapshot of the ongoing reconstruction
-ProgDsply: Displays the reconstruction progress until completion or until a key is pressed
Example
CmdTool2 -LDRecon -Start -r5 -Add -Physdrv[E0:S4] -l0 -a0
LDSetProp
Description
Change virtual drive cache and access parameters
Syntax
CmdTool2 -LDSetProp {-Name [ArrayName]} | -RW | RO | Blocked |
WT | WB | RA | NORA | ADRA
| Cached|Direct | -EnDskCache|DisDskCache |
CachedBadBBU|NoCachedBadBBU -L
[drive] -a[controller]
Parameters
-Name [ArrayName]: Name the array with a defined name [ArrayName]
-RW: Set the array to read-write
-RO: Set the array to read-only
-Blocked: Blocked array access
-WT: Set the array to write-through
-WB: Set the array to write-back
-RA: Set the array to read-ahead
-NORA: Set the array to no read-ahead
-ADRA: Set the array to adaptive read ahead
-Cached, Direct: Selects cache policy
-CachedBadBBU|NoCachedBadBBU: Specifies whether to use write cache when the BBU is bad
-EnDskCache, DisDskCache: Enables and disables drive cache