Command Line Tool 2 User Guide

PDPrpRmv
Description
Prepare an unconfigured physical drive(s) for removal. The drive is spun down and the drive state
is set to unaffiliated, which marks it as offline even though it is not a part of the configuration.
Syntax
CmdTool2 -PDPrpRmv [-Undo] -PhysDrv[E0:Sn....] -a[controller]
Parameters
-a[controller]: The RAID controller affected by the command
-PhysDrv[E0:Sn....]: The physical drive(s) affected
-Undo: Marks a drive as unconfigured-good
Example
CmdTool2 -PDPrpRmv -PhysDrv[252,0] -a0
PDRbld
Description
Start, stop, or display the progress of a physical disk rebuild. The command begins immediately if
not in DOS. The drive affected must be part of an array and have sufficient capacity.
Syntax
CmdTool2 -PDRbld -Start | -Stop | -ShowProg | -ProgDsply -PhysDrv [E0:Sn....] -
a[controller]
Parameters
-a[controller]: The RAID controller affected by the command
-Start: Start the physical disk rebuilding
-Stop: Stop the physical disk rebuilding
-ShowProg: Displays a snapshot of the ongoing rebuild
-ProgDsply: Displays the rebuild progress until completion or until a key is pressed