Command Line Tool 2 User Guide

Syntax
CmdTool2 -Snapshot -SetProp {-AutoSnapshot -val} | {-AutoDeleteOldestSnapshot -val}
-L[drive] -a[controller]
Parameters
-a[controller]: The RAID controller affected by the command
-L[drive]: specifies the source LD number for the command.
-AutoSnapshot: If the value is 0, this command disables the AutoSnapshot feature on source virtual
drive. If the value is 1, it enables the AutoSnapshot feature on source virtual drive
-AutoDeleteOldestSnapshot: If the value is 0, this command disables the
AutoDeleteOldestSnapshot feature on the source virtual drive. If the value is 1,i n enables the
AutoDeleteOldestSnapshot feature on the source virtual drive.
Example
CmdTool2 -snapshot -Enbl -sz10GB SnapshotRepositoryLD 0 -L1 -a1
-TakeSnapshot
Description
Take Snapshot of volume
Syntax
CmdTool2 -Snapshot -TakeSnapshot [-snapshotName name] [-CreateView [-ViewName
view_name] [-RW|RO|Blocked] [-szXXX]] -L[drive] -a[controller]
Parameters
-a[controller]: The RAID controller affected by the command
-L[drive]: specifies the source LD number for the command.
-snapshotName name: (Optional) If specified, the snapshot is createdwith the name you enter for it.
-CreateView: (Optional) If specified, this creates a view for the snapshot. A view contains the
content from the Point-in-Time [PiT] when the snapshot was made.
-ViewName view_name: (Optional) Specifies the name of the view you created.
-RW|RO|Blocked: Optional Parameter, specifies the access policy of the view.