Service Guide

Appendix B: Safety Information
90 Intel
®
Server System SC5650HCBRP Service Guide
Site Selection
The system is designed to operate in a typical office environment. Choose a site that is:
• Clean, dry, and free of airborne particles (other than normal room dust).
• Well-ventilated and away from sources of heat including direct sunlight and radiators.
• Away from sources of vibration or physical shock.
• Isolated from strong electromagnetic fields produced by electrical devices.
• In regions susceptible to electrical storms, we recommend you plug your system into a surge suppressor and
disconnect telecommunication lines to your modem during an electrical storm.
• Provided with a properly grounded wall outlet.
• Provided with sufficient space to access the power supply cord(s), because they serve as the product's main power
disconnect.
Equipment Handling Practices
Reduce the risk of personal injury or equipment damage:
• Conform to local occupational health and safety requirements when moving and lifting equipment.
• Use mechanical assistance or other suitable assistance when moving and lifting equipment.
• To reduce the weight for easier handling, remove any easily detachable components.
Power and Electrical Warnings
Caution: The power button, indicated by the stand-by power marking, DOES NOT completely turn off the system AC
power, 5V standby power is active whenever the system is plugged in. To remove power from system, you must
unplug the AC power cord from the wall outlet. Your system may use more than one AC power cord. Make sure all
AC power cords are unplugged. Make sure the AC power cord(s) is/are unplugged before you open the chassis, or
add or remove any non hot-plug components.
Do not attempt to modify or use an AC power cord if it is not the exact type required. A separate AC cord is required
for each system power supply.
Some power supplies in Intel
®
servers use Neutral Pole Fusing. To avoid risk of shock use caution when working with
power supplies that use Neutral Pole Fusing.
The power supply in this product contains no user-serviceable parts. Do not open the power supply. Hazardous
voltage, current and energy levels are present inside the power supply. Return to manufacturer for servicing.
When replacing a hot-plug power supply, unplug the power cord to the power supply being replaced before removing
it from the server.
To avoid risk of electric shock, turn off the server and disconnect the power cord, telecommunications systems,
networks, and modems attached to the server before opening it.
Power Cord Warnings
If an AC power cord was not provided with your product, purchase one that is approved for use in your country.
Caution: To avoid electrical shock or fire, check the power cord(s) that will be used with the product as follows:
• Do not attempt to modify or use the AC power cord(s) if they are not the exact type required to fit into the
grounded electrical outlets.
• The power cord(s) must meet the following criteria:
 The power cord must have an electrical rating that is greater than that of the electrical current
rating marked on the product.
 The power cord must have safety ground pin or contact that is suitable for the electrical outlet.
 The power supply cord(s) is/are the main disconnect device to AC power. The socket outlet(s) must
be near the equipment and readily accessible for disconnection.
 The power supply cord(s) must be plugged into socket-outlet(s) that is /are provided with a suitable
earth ground.
System Access Warnings
Caution: To avoid personal injury or property damage, the following safety instructions apply whenever accessing
the inside of the product:
• Turn off all peripheral devices connected to this product.
• Turn off the system by pressing the power button to off.