Service Guide

Server System Features
14 Intel
®
Server System SC5650HCBRP Service Guide
Expander Backplane Connector Locations
The Intel
®
Server System SC5650HCBRP integrates one expander backplane cage supports up to six hot-
swap SAS or SATA hard disk drives at 1.5GB/s or 3GB/s.
/
NOTE
SATA controllers cannot be used with expander backplane. SAS controller add-in card or SAS module card is
required to support expander backplane.
A
Power Cable Connectors
B
SAS Data Cable Connectors
C
HSBP_IPMB Connectors
Figure 12. Expander Backplane Connector Locations
Hardware Requirements
To avoid integration difficulties and possible board damage, your system must meet the following requirements
outlined. For a list of qualified components, see the links under “Additional Information and Software”.
Processor
One or two Intel
®
Xeon
®
Processor 5500 series up to 95-W.
One or two Intel
®
Xeon
®
Processor 5600 series up to 130-W.
For a list of supported processors, see the links under “Additional Information and Software”.
You must populate processors in sequential order. Therefore, you must populate Processor Socket 1 (CPU 1)
before processor socket 2 (CPU 2).