Service Guide

Hardware Installations and Upgrades
28 Intel
®
Server System SC5650HCBRP Service Guide
3 Hardware Installations and Upgrades
This chapter provides instructions for adding and replacing chassis components.
Before You Begin
Before working with your server product, pay close attention to “Appendix B: Safety Information”.
Tools and Supplies Needed
 Phillips* (cross head) screwdriver (#1 bit and #2 bit)
 Needle nosed pliers
 Hex nut driver (6 mm)
 Antistatic wrist strap and conductive foam pad (recommended)
System Reference
All references to the left, right, front, top, and bottom assume the reader is facing the front of the system
chassis as it would be positioned for pedestal operation.
Removing and Installing the Left Side Cover
WARNING
This system chassis must be operated with the left side cover installed to ensure
proper cooling.
Removing the Left Side Cover
The Intel
®
Server System SC5650HCBRP must be operated with the left side cover in place to ensure proper
cooling. You must remove the left side cover to add or replace components inside of the platform. Before
removing the left side cover, power down the server and unplug all peripheral devices and the AC power cable.
/
NOTE
You may need a non-skid surface or a stop behind the chassis to prevent the chassis from sliding on
your work surface.
1. Observe the safety and ESD precautions listed in “Appendix B: Safety Information”.
2. Turn off all peripheral devices connected to the server. Turn off the server.
3. Disconnect the AC power cord(s).