Service Guide

Hardware Installations and Upgrades
Intel® Server System SC5650HCBRP Service Guide 55
Figure 59. Reinstall Right Side Cover on Chassis
12. Reinstall the front bezel assembly. For instructions, see “Installing the Front Bezel Assembly”.
13. Reinstall the left side cover. For instructions, see “Installing the Left Side Cover”.
14. Reconnect all peripheral devices and the AC power cable. Power up the server.
Replacing Rear System Fan
CAUTIONS
The system fan for the Intel
®
Server System SC5650HCBRP is NOT hot swappable. Before removing or
replacing a fan, you must first take the server out of service, turn off all peripheral devices connected to the
system, turn off the system by pressing the power button, and unplug the AC power cord from the system or
wall outlet.
1. Observe the safety and ESD precautions listed in “Appendix B: Safety Information”.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the left side cover. For instructions, see “Removing the Left Side Cover”.
4. Remove the system fan duct. For instructions, see “Removing and Installing System Fan Duct”.
5. Disconnect the fan power cable from the server board (see letter “A” in the following figure). Remove the
system fan from its snap-in bracket by pressing the two bracket tabs outward (see letter “B”).