SOL White Paper

To exit SOL and return to the SMBridge prompt, press the tilde key and the period key (that is,
~.). For more information, see:
http://www.microsoft.com/resources/documentation/WindowsServ/2003/standard/proddocs/en
-us/EMS_SAC_commands.asp
To enable EMS on a Windows Server 2003*, do the following:
1. Log in to Windows* as an administrator.
2. Launch a command prompt and enter the command bootcfg, as shown in Figure 4.
Figure 4: Windows* EMS screen
• Examine the output. If there is more than one boot entry then you will need to
determine the default entry by looking at the default line under Boot Loader Settings
and determining whether Boot Entry has a matching Path value. In this case, there is only
one boot entry, 1.
• Issue the following command, substituting your boot entry number in the /id parameter if
it is not 1 as in example.
bootcfg /ems on /port com2 /baud 115200 /id 1
NOTE: In order to enable perform this step, you need enable console redirection on COM2 (SOL
session) with baud rate 115200 in advance for this setting.
Page 9 5/26/2010