Users guide

Intel® RAID Software User Guide 268
10.5.3 Drive Commands
This section describes the drive commands, which provide information and perform
actions related to physical drives. The following table describes frequently used virtual
drive commands.
Table 26. Physical Drives Commands Quick Reference Table
10.5.3.1 Drive Show Commands
The Storage Command Line Tool supports the following drive show commands:
storcli /cx[/ex]/sx show
storcli /cx[/eall]/s
all show
storcli /cx[/ex]/sx|
sall show all
Note: If enclosures are used to connect physical drives to the controller, specify the enclosure ID
in the command. If no enclosures are used, you must specify the controller ID and slot ID.
The detailed description for
each command follows.
storcli /cx[/ex]/sx show
This command shows the summary of the physical drive for a specified slot in the
controller.
Input example:
storcli /c0/e0/s4,5 show
storcli /cx[/eall]/s
all show
This command shows the summary information for all the enclosures and physical drives
connected to the controller.
Input example:
storcli /c0/eall/sall show
Command Value Range Description
set missing: Sets the drive status
as missing.
good: Sets the drive status to unconfigured
good.
offline: Sets the drive status
to offline.
online: Sets the drive status to online.
Sets physical drive properties.
show all: Sho
ws all properties of the physical
drive.
See “Drive Show Commands” on page268.
Shows virtual drive information.