Users guide

275 Intel® RAID Software User Guide
storcli /cx[/ex]/sx show rebuild
This command shows the progress of the rebuild process in percentage.
Input example:
storcli /c0/s5 show rebuild
storcli /cx[/ex]/sx start rebuild
This command starts a rebuild operation for a drive.
Input example:
storcli /c0/s4 start rebuild
storcli /cx[/ex]/sx stop rebuild
This command stops a rebuild operation. You can run this command only for a drive that
is currently rebuilt.
Input example:
storcli /c0/s4 stop rebuild
10.5.3.11 Drive Copyback Commands
The Storage Command Line Tool supports the following commands for drive copyback:
storcli /cx[/ex]/sx pause copyback
storcli /cx[/ex]/sx resume copyba
ck
storcli /cx[/ex]/sx show copyback
storcli /cx[/ex]/sx start copybac
k target=eid:sid
storcli /cx[/ex]/sx stop copyback
The detailed description for each command follows.
Note: In
the copyback commands, cx[/ex]/sx indicates the source drive and eid:sid
indicates the target drive.
Note: Wh
en a copyback operation is enabled, the alarm continues to beep even after a rebuild is
complete; the alarm stops beeping only when the copyback operation is completed.
storcli /cx[/ex]/sx pause copyback
This command pauses a copyback operation. You can run this command only when there
is a copyback operation running.
Input example:
storcli /c0/e25/s4 pause copyback
storcli /cx[/ex]/sx resume copyba
ck
This command resumes a paused copyback operation. You can run this command only
when there is a paused copyback process for the drive.