Users guide

Intel® RAID Software User Guide 276
Input example:
storcli /c0/e25/s4 resume copyback
storcli /cx[/ex]/sx show
copyback
This command shows the progress of the copyback operation in percentage.
Input example:
storcli /c0/e25/s4 show copyback
storcli /cx[/ex]/sx
start copyback target=eid:sid
This command starts a copyback operation for a drive.
Input example:
storcli /c0/e25/s4 start copyback target=25:8
storcli /cx[/ex]/sx stop
copyback
This command stops a copyback operation. You can run this command only on drives that
have the copyback operation running.
Input example:
storcli /c0/e25/s4 stop copyback
Note: A stopped rebuild process cannot be resumed.
10.5.3.12 Hot Spare Drive Commands
The following commands create and delete hot spare drives:
storcli /cx[/ex]/sx add hotsparedrive
{dgs=<n|0,1,2...>}[enclaffinity][nonrevertible]
storcli /cx/[ex]/sx delete
hotsparedrive
Note: If enclosures are used to connect the physical drives to the controller, specify the
enclosure ID in the command.
The detailed description for
each command follows.
storcli /cx[/ex]/sx add hotsparedrive [{dgs=<n|0,1,2...>}]
[enclaffinity][nonrevertible]
This command creates a hot spare drive. You can use the following options to create a hot
spare drive.
Table 28. Add Hotsparedrive Input Options
Option Value Range Description
dgs Valid drive group number Specifies the drive group to which the hot
spare
drive is dedicated.