Users guide

291 Intel® RAID Software User Guide
storcli /cx set autobootselect|abs=<on|off>
This command enables the BIOS to select the best logical drive as the boot drive.
Input example:
storcli /cx set autobootselect=on
storcli /cx se
t bios=<on|off>
This command enables or disables the Intel
®
RAID Controller's BIOS.
Note: The legacy
BIOS can load a limited number of the PCI device's BIOS. Disable the Intel
®
RAID BIOS to avoid issues during POST.
Input example:
storcli /c0 set bios=enable
storcli /cx se
t BIOSMode=<SOE|BE|HCOE|HSM
This command sets the BIOS boot mode.
Input example:
storcli /c0/ set BIOSMode=SOE
10.5.6.1 OPROM BIOS Commands
The Storage Command Line Tool supports the following OPROM BIOS commands:
storcli /cx/ex/sx set bootdrive=on|off
storcli /cx/vx set bootdrive=on|o
ff
storcli /cx sh
ow bootdrive
The detailed description for each command follows.
storcli /cx/ex/sx set bootdrive=on|off
This command sets the specified physical drive as the boot drive. During the next reboot,
the BIOS looks for a boot sector in the specified physical drive.
Input example:
storcli /c0/e32/s4 set bootdrive=on
storcli /cx/vx set bootdrive=on|o
ff
This command sets the specified virtual drive as the boot drive. During the next reboot,
the BIOS looks for a boot sector in the specified virtual drive.
Input example:
storcli /c0/v0 set bootdrive=on