Users guide

297 Intel® RAID Software User Guide
Input example:
storcli /c0/bbu show status
storcli /cx/bb
u start learn
This command starts the BBU learning cycle. The battery learn cycle is immediately
started and no other parameters are required for this command.
Input example:
storcli /c0/bbu start learn
10.5.10 Enclosure Commands
The Storage Command Line Tool supports the following enclosure commands:
storcli /cx/ex download src=filepath [forceActivate]
storcli /cx/ex show all
storcli /cx/ex show status
The detailed description for each command follows.
storcli /cx/ex download src=filepath [forceactivate]
This command flashes the firmware with the file specified at the command line. The
enclosure performs an error check after the operation. The following option can be used
with the enclosure firmware download command.
Table 36. Enclosure Firmware Download Command Options
Note: The fi
rmware file that is used to flash the enclosure can be of any format. The StorCLI
utility assumes that you provide a valid firmware image.
Input example:
storcli /c0/e0 download src=c:\file2.bin
storcli /cx/ex show all
This command shows all enclosure information, which includes general enclosure
information, enclosure inquiry data, a count of enclosure elements, and information about
the enclosure elements.
Input example:
storcli /c0/e0 show all
Option Value Range Description
forceactivate — Issues a command descriptor block (CDB) with
w
rite command with no data with command mode
0x0F (flash download already in progress).
Note: T
his option is used primarily to activate
Scotch Valley Enclosures.