Users guide

Intel® RAID Software User Guide 314
7. Click Back to return to the previous screen to change any selections or click Finish
to accept and complete the configuration.
The new storage configuration will be created and initialized.
Note: If you cr
eate a large configuration using drives that are in powersave mode, it
could take several minutes to spin up the drives. A progress bar appears as the
drives spin up. If any of the selected unconfigured drives fail to spin up, a box
appears to identify the drive or drives.
8. After the configuration is com
pleted, a dialog box notifies you that the virtual
drives were created successfully, as shown in Figure 183. If more drive capacity
exists, the dialog box asks whether you want to create more virtual drives. If no
more drive capacity exis
ts, you are prompted to close the configuration session.
Figure 183. Option to Create Additional Virtual Drives
9. Select Ye
s or No to indicate whether you want to create additional virtual drives.
If you select Ye
s, the system takes you to the Create Virtual Drive screen, as
shown in Figure 96. If you select No, the utility asks whether you want to
close the
wizard, as Figure 184.
10. If you selected No in <hypera
ctive>step 8, select Yes or No to indicate whether you
want to close the wizard.
If you select Ye
s, the configuration procedure closes. If you select No, the dialog
box closes and you remain on the same page.
Figure 184. Option to Close the Configuration Wizard