Datasheet

Input/Output
PCI Four independent PCI buses, adapter slots
on risers; 1U system Option 1: two PCI-X
100MHz, Option 2: one PCI Express* x8
and one PCI-X 100MHz; 2U system Option
1: six PCI-X 66/100MHz, Option 2: two
PCI-X 133 MHz (active) and four PCI-X
66/100MHz, Option 3: two PCI Express*
x4 and four PCI-X 66/100MHz
8
IDE Dual-channel EIDE for a total of four IDE
devices (two on ATA connector, two on
high-density connector to backplane)
USB Two USB 2.0 ports (rear) and two USB
headers for up to four additional external
USB ports
Serial Ports One asynchronous RJ45 Serial B port with
one DH10 10-pin internal Serial A header
Floppy Controller 1.44 MB and 2.88 MB, 3-mode support
Keyboard/Mouse Two PS/2* ports, 8240A-compatible
Intel
®
Server Management
Integrated Management Onboard Platform Instrumentation
Type
Software support Intel
®
Server Manager 8 family of
software; upgradable to support HP
Unicenter*, Tivoli*, and LANDesk*
Management Suite 8
Intel
®
Management Professional and Advanced Editions
Module Support
Supported Standards IPMI, DMI, CIM, SNMP, ICMB
Fully Validated Operating Systems
Microsoft* Windows* Server 2003, Microsoft Windows 2000
Advanced Server, Red Hat* Linux*, SUSE* LINUX*, and Novell*
NetWare*
System BIOS
Type AMI*
Special Features Plug and Play, IDE drive autoconfigure,
SMBIOS 2.3, ECC/Parity support,
multilingual support, enabled for
rolling/online BIOS updates
Configuration Utilities Server Configuration Wizard for system
setup of BIOS utilities; Save and Restore
System Configuration Utility and initial
Intel Server Management configuration
Processor
One or two Intel
®
Xeon
™
processors with an 800MHz system bus;
for the latest processor support information, visit
http://support.intel.com/support/motherboards/server/se7520jr2
M
System Memory
For the latest information on memory support, visit
http://support.intel.com/support/motherboards/server/se7520jr2
Capacity Six DIMM sockets for up to 24 GB of
Registered ECC DDR 266 or 16 GB of
Registered ECC DDR 333 or DDR2 400;
memory must be populated in pairs
Type Registered ECC DDR 266/333 SDRAM
72-bit, 184-pin gold-plated DIMMs; DDR2
400
Reliability Features Corrects single-bit errors, detects double-
bit errors (using ECC memory); supports
Intel
®
x4 Single Device Data Correction
(SDDC), scrubbing, retry on uncorrectable
errors, memory sparing, memory mirroring
Integrated Onboard
Chipset Intel
®
E7520 chipset
Intel
®
Server Network Two Intel
®
PRO/1000 MT Server Network
Connections Connections (Intel
®
82546GB controller);
supports 10BASE-T, 100BASE-TX, and
1000BASE-T, dual RJ45 outputs
Super I/O Controller National Semiconductor* PC87427
Integrated Management National Semiconductor PC87431M
Controller mini-Baseboard Management Controller
Graphics ATI* RAGE* XL SVGA PCI video controller
with 8 MB of video memory
Integrated Storage Support
Parallel ATA Dual-channel ATA 100 (integrated single
connector and service to backplane)
Serial ATA Dual-channel SATA 100 (two connectors)
integrated with RAID 0 and 1 support
Ultra320 SCSI
9
Dual-channel Ultra320/LVD SCSI via LSI
Logic* LSI53C1030 controller: connected
via one internal 68-pin-wide connector
and one 68-pin high-density external SCSI
connector; maximum data transfer 320
MB/sec on each Ultra320/LVD channel;
supports HostRAID* embedded SCSI
striping/mirroring (RAID 0 and 1)
Jumpers
CMOS clear, password clear, BIOS recovery, BMC boot block
write protect
Front-Panel Support
Power LED, hard-drive activity LED, two network activity LEDs,
system-ID LED, system-status LED; power on/off button, system
reset button, system ID button, and NMI switch; optional Intel
®
Local Control Panel
6
for monitoring and control of the server from
the front panel
Mechanical
Board Style SSI Thin E-Bay v3.1
Board Size 12" x 13" (305 mm x 269 mm)
Environment
Ambient Temperature Operating (system): 10°C to 35°C;
non-operating/storage (system): –40°C
to +70°C ambient
Relative Humidity Non-operating 95%, non-condensing
at 30°C
Safety and EMC Regulatory Compliance (Class A)
(EMC Regulatory Compliance is based on a board configured in
an Intel host system in which Intel tested the board and found it
compliant.)
Country Certification Regulatory Mark
Safety and/or EMC Safety and/or EMC
Australia/ ACA, MED C-Tick
New Zealand
Canada UL / Industry Canada cURus / ICES
Europe European Directives CE
International CB Report / CISPR Not applicable
Japan VCCI (Verification only) Not applicable
Korea RRL MIC
Russia GOST GOST
Taiwan BSMI DOC BSMI
United States UL / FCC (Verification only) cURus
Intel
®
Server Board SE7520JR2 Specifications
1
Intel
®
Extended Memory 64 Technology (Intel
®
EM64T) requires a computer system with a processor, chipset, BIOS, OS, device drivers and applications enabled for Intel EM64T. Processor will not operate
(including 32-bit operation) without an Intel EM64T-enabled BIOS. Performance will vary depending on your hardware and software configurations. Intel EM64T-enabled OS, BIOS, device drivers and
applications may not be available. Check with your vendor for more information.
2
Enhanced Intel SpeedStep
®
technology is available on Intel
®
Xeon
™
processors with an 800MHz system bus at operating frequencies of 3.40 GHz and above.
3
The Intel
®
Server Board SE7520JR2 supports PCI Express* x8 in its 1U configuration and PCI Express x4 in its 2U configuration.
4
PCI-X bus speed depends on board model and number of PCI-X slots that are populated.
5
Features may vary depending on system configuration and may require the purchase and installation of an optional Intel
®
Management Module upgrade.
6
The Intel
®
Local Control Panel requires the purchase and installation of an optional Intel
®
Management Module upgrade.
7
Features sets may vary by board model. See http://www.intel.com/go/serverbuilder for more detail.
8
Based on PCI riser support.
9
SCSI support is available with product order codes SE7520JR2SCSID1 and SE7520JR2SCSID2.