Computer Hardware User Manual

English
19
3.4. Integrated Peripherals
ø This menu allows you to control the various ports of the computer such as IDE,
SATA, USB, IEEE1394, COM port, LPT port, AC97 audio, etc.
n On-Chip Primary PCI IDE
Allows the user to enable or disable the first onboard IDE channel.
(default:Enabled)
n On-Chip Secondary PCI IDE
Allows the user to enable or disable the second onboard IDE channel.
(default:Enabled)
n No-Execute Memory Protect
(Note)
Allows user to enable the No-Execute Memory Protect function. (default: Disabled)
n CPU Enhanced Halt (C1E)
(Note)
Allows user to enable the CPU Enhanced Halt (C1E) function. (default: Disabled)
n CPU Thermal Monitor 2(TM2)
(Note)
Allows user to enable the CPU Thermal Monitor 2(TM2) function. (default: Disabled)
n Init Display First
Allows you to select whether to boot the system using the AGP graphics card or the PCI
graphics card.
Options: AGU (boot using AGU graphics card)
Onboard (boot using onboard AGP)
PCI(boot using PCI graphics card). (default: AGU)
n On-Chip Frame Buffer Size
Allows user to set the size of the on-chip frame buffer.
Options: 1MB/4MB/8MB/16MB/32MB (default:16MB)
CMOS Setup Utility-Copyright (C) 1984-2005 Award Software
Integrated Peripherals
On-Chip Primary PCI IDE [Enabled]
On-Chip Secondary PCI IDE [Enabled]
On-Chip SATA [Auto]
x SATA Port0 Configure as SATA Port0
x SATA Port1 Configure as SATA Port1
USB Controller [Enabled]
USB 2.0 Controller [Enabled]
USB Keyboard Support [Disabled]
USB Mouse Support [Disabled]
AC97 Audio [Auto]
Onboard H/W LAN [Enabled]
POWER ON Function [Disabled]
Onboard Serial Port 1 [3F8/IRQ4]
Onboard Parallel Port [378/IRQ7]
Parallel Port Mode [PRINTER]
x ECP Mode Use DMA 3
higf: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level}
If a hard disk
controller card is
used, set at Disabled
[Enabled]
Enable onboard IDE
PORT
[Disabled]
Disable onboard IDE
PORT
(Note) If the installed CPU supports this function, the system will automatically provide this
option.