User Manual

Installation
1. Power off the source and destination devices which will be connected to the
extenders.
2. VerifythemodularoutletsandcrossconnectstowhichyouwillconnecttheAVO‐USB
areconfiguredproperlyandlabeledappropriatelytoidentifythecircuit.





3. Verify the desired twisted pairs are not
 being used for other LAN or telephone
equipment.





4. ConnecttheAVO‐USB‐HtotheUSBportofthehostdevice,typicallyacomputer.
5. Connectone end of the twisted pair cableto the send extender. The RJ45 pinout in
thetwistedpaircablingshouldconformtothe
EIA/TIA568Aor568Bstandard.
6. Connectacompatibletransmittertotheclientdevice,typicallyakeyboardormouse.
7. Connect the other end of the twisted pair cable to the receive extender. The RJ45
pinout in the twisted pair cabling should conform to the EIA/TIA 568A or 568B
standard.



8. Poweronthesourceanddestinationequipment.
Caution: Do not connect the extender to a telecommunication outlet wired
to unrelated equipment. Doing so may damage the unit or any connected
equipment. Ensure all connected twisted pair cabling is straight-through
(point-to-point
).
Caution: To minimize the possibility of equipment damage from
electrostatic discharge (ESD), all source and destination equipment must
be powered off during installation. This includes signal extenders, splitters,
a
n
d
sw
i
tc
h
es.
Note: For your convenience, it is recommended that you uniquely mark
the ends of the twisted pair cable before pulling them through a wall or
Note: The AVO-USB supports speeds up to 12 Mbps. Distance is
dependent on transmission speeds. Please refer to the technical
specifications for maximum distances.