Owners manual

Connection of the Cable

Remove the rubber cap from RF connector. Connect the RF cable to the

RF connector under the base plate through the access hole using an

11mm spanner. Be careful not to over tighten, as you may damage the

connector.

Note: Do not use excessive force when using the spanner, this will

damage the threads. Be careful that the connectors do not contact the

mounting surface of the antenna, this may cause a critical malfunction

and serious damage to the equipment.

Securing Holes for Bolts and Cable Way

Make 4 bolt holes of 10mm diameter, one at each corner of a rectangle

drawn as below, and make a circular hole of 80mm diameter at the

center of the rectangle through which the cable will run.

Figure 10 : Drilling Instruction

Ø80mm

Hole Saw

Ø 10mm

Drill

Figure 11 : Connectors on Bottom of Antenna

Antenna Unit

RF Cables

11mm

Spanner