Users Manual

ManualsBrandsIntellifire ManualsSmart HomeIFT-RC150 IntelliFire Touch Wireless Wall Switch

Hearth & Home Technologies • IFT-RC150U User Manual • 2564-981 • 11/20

User Manual

IFT-RC150

IFT-RC150 IntelliFire Touch Wireless Wall Switch

Model: 2564-100

Introduction

The IFT-RC150 is a wall-mounted wireless wall switch

that is designed to operate Hearth & Home Technologies

appliances equipped with the IntelliFire Touch

Technology. It has a temperature sensor and can be

used to control the ON/OFF and cold-climate func-

tion of your appliance as a stand-alone or in combi-

nation with a Mobile App. This user manual serves

as a quick reference to the wall switch operation.

Operation

Pairing

• The IFT-RC150 must be paired to control the Elec-

tronic Control Module (ECM). The pairing button is

located underneath the top housing cover.

• Remove IFT-RC150 top housing cover. Install 2

AA alkaline batteries.

• The pairing button will activate the pairing mode of the

wireless wall switch for 15 seconds while the LED

indicator blinks once every second.

• To pair the IFT-RC150 with the IFT ECM, press the

pairing button on the ECM. When the ECM green

LED starts blinking, press the pairing button on the

IFT-RC150. If pairing is successful, the ECM will

respond with a double beep and the green LED will

stop blinking. Re-install the IFT-RC150 top housing

cover.

Flame ON/OFF

• To turn the ame ON, press the top of the momentary

toggle switch.

• To turn the ame OFF, press the bottom of the

momentary toggle switch.

The appliance has a safety feature that automatically

shuts down the appliance after 9 hours of continuous

operation.

Cold Climate

This function turns on a continuous pilot and keeps the air

inside the appliance warm while not in use. It is a useful

feature in cold weather to minimize condensation on the

appliance glass.

• To turn the cold climate mode ON/OFF, press the small

momentary push button below the momentary toggle

switch.

Note: This feature is disabled when a Power Vent is

installed on the appliance.

Note: The continuous pilot will automatically turn OFF

after 166 hours if appliance is not actively used.

If Flame ON is activated before 166 hours, the

automatic timer will re-start.

FIRMWAREFIRMWARE

PROGRAMMINGPROGRAMMING

ACCESS ACCESS

Figure 1. IFT-RC150 No Top Cover

Figure 1. IFT-RC150 Functions

RED/GREEN LEDRED/GREEN LED

COLD CLIMATE ON/OFFCOLD CLIMATE ON/OFF

FLAME ONFLAME ON

FLAME OFFFLAME OFF

LEDLED

COLD CLIMATECOLD CLIMATE

CONTROL BUTTONCONTROL BUTTON

PAIRING PAIRING

BUTTON HOLE BUTTON HOLE

AA AA

BATTERYBATTERY

HOLDERHOLDER

ON/OFF ON/OFF

SWITCHSWITCH

Summary of content (4 pages)

PAGE 1
IFT-RC150 IFT-RC150 IntelliFire Touch Wireless Wall Switch Model: 2564-100 User Manual Introduction Flame ON/OFF The IFT-RC150 is a wall-mounted wireless wall switch that is designed to operate Hearth & Home Technologies appliances equipped with the IntelliFire Touch® Technology. It has a temperature sensor and can be used to control the ON/OFF and cold-climate function of your appliance as a stand-alone or in combination with a Mobile App.
PAGE 2
LED Indicator Manual Fireplace Shutoff • A single two-color LED indicator is located above the momentary toggle switch. The LED indicator identifies to the user the IFT-RC150 status. In the unlikely event that the wall switch malfunctions and will not turn off the fireplace, call your dealer for service assistance. In the meantime, turn off your appliance by performing the following actions: • GREEN: Blink during normal transmission. • RED: Blinks once every 5 seconds indicating Low Battery.
PAGE 3
Frequently Asked Questions/Troubleshooting Symptom Possible Cause The appliance does not respond to Batteries are depleted. commands from the wireless wall switch Batteries are incorrectly installed. and the LED does not blink. The appliance does not respond to commands from the wireless wall switch but the LED blinks alternating RED and The wireless wall switch is not paired GREEN. to or lost communication with the electronic control module.
PAGE 4
Regulatory Certification Canada The IFT-RC150 wireless wall switch is certified for operation in the following countries: The IFT-RC150 is certified for use in Canada under Industry Canada (IC) Radio Standards Specification (RSS). • United States • Canada United States The IFT-RC150 complies with all applicable FCC equipment authorization, regulations, requirements, and equipment functions.