- IMS Integrated Motor and Driver Product Manual

A-16
MDrive 34Plus Microstepping Hardware - Revision R071108
Relevant to Firmware Version 3.0.02
Note: Interactive
installation tutorials
are available at
the IMS Web Site
at http://www.imshome.com/
tutorials.html
Connector Detail and Mating Connector Kit
Should you choose to create your own interface cable IMS now has mating connector kits available which
assist you in creating interface cables in small quantities. These kits come with the connector shells and crimp
pins (if applicable) to create five interface cables.
Connector Details
Mating Connector Kit p/n: CK-01
Description: 5 mating connector shells for making interface cables to MDrive’s 10-pin IDC connector.
2-piece connector shell crimps onto a 10 conductor AMP ribbon cable. Ribbon Cable is
not included.
IDC Parts: Shell: SAMTEC TCSD-05-01-N
Ribbon Cable: AMP 1-57051-9
Figure C.2: 10-Pin IDC
MISO
+5 VDC Out*
Chip Select
MOSI
SPI Clock
GND
1
3
5
7
9
2
4
6
8
10
pins not labeled are no connect.
*used to power the MD-CC300-001 only.