- IMS Integrated Motor and Driver Product Manual

A-19
Appendices
Installation Procedure for the MD-CC30x-000
These Installation procedures are written for Microsoft Windows XP Service Pack 2 or greater.
The installation of the MD-CC30x-001 requires the installation of two sets of drivers, which may be downloaded
from http://www.imshome.com:
 Drivers for the IMS USB to SPI Converter Hardware.
 Drivers for the Virtual Communications Port (VCP) used to communicate to your IMS Product.
Therefore the Hardware Update wizard will run twice during the installation process.
The full installation procedure will be a two-part process: Installing the Cable/VCP drivers and Determining the
Virtual COM Port used.
Installing the Cable/VCP Drivers
1) Download dirvers from http://www.imshome.com/cable_drivers.html.
2) Extract the driver files from the *.zip archive, remember the extracted location.
3) Plug the USB Converter Cable into the USB port of the MD-CC30x-001.
4) Plug the other end of the USB cable into an open USB port on your PC.
5) Your PC will recognize the new hardware and open the Hardware Update dialog.
6) Select “No, not this time” on the radio buttons in answer to the query “Can Windows Connect to
Windows Update to search for software?” Click “Next” (Figure C.5).
7) Select “Install from a list or specific location (Advanced)” on the radio buttons in answer to the query
“What do you want the wizard to do?” Click “Next” (Figure C.6).
Figure C.5: Hardware Update Wizard
Figure C.6: Hardware Update Wizard Screen 2